E. Emerson Tool Co. ZPK2 All-In-One A-Series Cabinet Maker Clamps, 2-Pack Reviews

Related Planing Tools Products

3 Responses to E. Emerson Tool Co. ZPK2 All-In-One A-Series Cabinet Maker Clamps, 2-Pack Reviews

  1. BoJonJovi says:
    1 of 1 people found the following review helpful
    3.0 out of 5 stars
    Good start poor finish, March 12, 2014
    By 
    BoJonJovi (Out there!) –

    Verified Purchase(What’s this?)
    This review is from: E. Emerson Tool Co. ZPK2 All-In-One A-Series Cabinet Maker Clamps, 2-Pack (Tools & Home Improvement)
    I started out really liking these clamps. I decided to make cabinets for my kitchen and at first I was really pretty wowed and jazzed by them. By the end of the job some of the rods had developed bite marks, became difficult to set and fix as they would not hold, and a couple became very sticky and moved with great difficulty from the beginning of the project. So I would say if you are a homeowner and occasional user they are great. If you are a contractor you will probably find yourself dragging out the table saw or shooting board after a month of heavy use. I can say they help a person get a table saw quality cut with a circular saw. I purchased this set and the long one to cut down 8 foot sheets. I might consider buying the long one again as I work alone and I do not like handling sheets on the table saw. I did find that when they get sticky some dry lube and silicon help byt it is not a cure. I would probably send them back because on the surface they look great but I suspect the manufacturer might consider them abused because of the bite marks in the metal. I really can not imagine how this might be avoided other than by being built with a higher quality steel.
    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  2. Brad says:
    1 of 1 people found the following review helpful
    5.0 out of 5 stars
    A handy set of clamps for your shop, November 12, 2013
    By 
    Brad

    Verified Purchase(What’s this?)
    This review is from: E. Emerson Tool Co. ZPK2 All-In-One A-Series Cabinet Maker Clamps, 2-Pack (Tools & Home Improvement)
    Each one of these clamps by themselves are great. Each size has its own special use and function. Whether you are using the small 12 inch clamp as an auxiliary fence for a bandsaw. Or, the 50 inch clamp as a guide for crosscutting or dadoing across a full sheet of plywood. They perform very well. The 50 inch twins makes glue ups and assemblies quite easy. I’ve even used the twins to hold my work, steady, while at the same time using the smaller clamps for routing. I’m sure I’ve only scratched the surface of what these clamps can do. And when priced individually, the cost of the all-in-one a series seems to me to be reasonable. A good value for the DIY.
    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  3. Carpenter 745 says:
    1 of 1 people found the following review helpful
    5.0 out of 5 stars
    ZPK2 Contractor kit, July 16, 2013
    By 
    Carpenter 745 (Honolulu, Hawaii) –

    Verified Purchase(What’s this?)
    This review is from: E. Emerson Tool Co. ZPK2 All-In-One A-Series Cabinet Maker Clamps, 2-Pack (Tools & Home Improvement)
    Just received my order from amazon and all I can say is that I am very satisfied with this product. I actually saved alot $$$ with this contractors pack if bought individualy. In my opinion E Emerson tool is alot better than the Bora set. I would highly recommend this set to everyone that is looking for a straight edge with miter t-slot. It is worth it, you won’t be dissapointed.
    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

Leave a Reply

Your email address will not be published. Required fields are marked *

Яндекс.Метрика